After months of waiting, I finally received my second batch of offset FUCA bushings in from machining. I made a few small changes from the initial batch, which I will outline here.

I have close to 50 sets of bushings this time so it’s a pretty big batch!

As always, a set will include enough bushings for both L and R sides. A total of four thick bushings (outer) and four thin bushings (inner).

The first changes come to the bushings themselves.

Added chamfer to leading edge to make it easier to align to the control arm for installation
Added corner relief which allows a perfectly flat seal when pressed in

Next change is to the inner sleeves. For the first batch I actually bought a long piece of stock and hand cut them one by one to the correct length.

Now made individually from 304 Stainless Steel
Tighter inner diameter tolerance
Tighter outer diameter tolerance. Now a slip fit before the bushing is installed, which turns into a light press after the bushing is installed and naturally compresses, making installation easier
Small chamfer on outer diameter, making installation easier

Just like before each set comes with 8 washers and 4 set screws.

For installation instructions: https://baero.tech/offset-bushings-install

Order yours today!